Air Movers & Fans

A long-running exhaust fan with a sealing shutter. Butterfly shutters open on startup and spring shut for a tight weather seal. Tight weather s...

A wet-rated fan for wash bays and patios. UL507 certified for indoor and outdoor use, with a tilt-and-swivel bracket and a 115V plug. Wet-locat...

A wet-rated wall fan that sweeps the area. 93 degrees of oscillation, three speeds up to 4,790 CFM and a 10' plug-in cord. Sweeps 93 degrees Th...

High airflow in a housing that will not rust. A 36" white poly fan with a G90 galvanized prop and a hot-dip galvanized bracket in the box. High...

Bring warm ceiling air back down to the floor. Low-speed vertical mixing that J&D says cuts the floor-to-ceiling temperature gradient by up to...

A plug-in exhaust fan rated for the weather. UL507 outdoor-certified motor, a built-in switch and a 9' cord pre-wired for 115V. Outdoor rated T...

A hanging basket fan with its bracket included. 3,340 to 9,810 CFM in four sizes, with a hot-dip galvanized mounting bracket in the box. Bracke...

Industrial air on a stand you can roll. Up to 6,520 CFM, an adjustable-height pole and a wide base on 4" rubber wheels. Rolls where needed A wi...

Wall or post-mounted air for work areas. 2,340 to 6,520 CFM from a 115V cord, with 2-speed fixed or 3-speed oscillating motors. Sweeps the area...

A steel drum fan built for heavy use. G90 galvanized steel, 11,800 to 23,500 CFM of tested thrust and a 115V cord on every size. G90 galvanized...

Fresh air pushed into tight spaces. A 1 HP, 20" Diamond Brite fan with an 8-blade prop built for duct pressure, plus 20' of safety-yellow duct. ...

Year-round air mixing from the ceiling. 9,415 CFM from a sealed, UL507 wet-listed fan that reverses for summer and winter. Reversible airflow A...

Two speeds and a tilting head on wheels. 7,760 CFM on high from a 1/6 HP direct drive motor, on a cart you aim and roll. Two speeds A HIGH/LOW ...

A basket fan built for corrosive, wash-down areas. 316 stainless guard, stainless prop and hardware, and an IP66 motor you can wash down from any ...

A rolling relief station with its own water tank. An oscillating UL507 fan, a 60 PSI mist pump and a 22-gallon tank that runs 5 to 8 hours. Hou...

A poly fan that hangs from its motor mount. One-piece polyethylene housing that will not rust, on a tilt-and-lock bracket that carries the motor. ...

Wall exhaust that installs as a plug-in. Galvanized housing, a self-closing aluminum shutter and corded models pre-wired for 115V. No electrici...

High-volume air you can roll to the job. 4,760 to 23,500 CFM of tested thrust from a 115V cord, in five sizes from 20" to 48". Measured airflow...

The Minuteman A3SM is a mini air mover for small spaces: a 10.5 lb unit whose sealed 1/5 HP three-speed motor moves up to 800 CFM on high. It sets ...

The Minuteman A3S is a three-speed air mover that delivers up to 1050 CFM from a sealed 1/3 HP motor, for drying carpet and floors after extraction...

The AlorAir Zeus Extreme is an axial air mover for water damage restoration, carpet drying and job site ventilation. Its 2-speed PSC motor pushes a...

The AlorAir Zeus 900 is a low-profile radial air mover for drying carpet and pad, walls, stairs and floors after water damage. It pushes about 950 ...

The AlorAir X-Force is a structural drying system that dries the inside of wet walls, ceilings and cabinets without tearing out drywall. A blower d...

The AlorAir X-Force Air Mover Base Unit is the blower on its own: the drive unit of the X-Force wall cavity drying system. Use it to add a second d...