AlorAir GE4000TC 4000 CFM Air Mover with Timer and Carpet Clamp
Product support & personalised quotes
Monday to Friday 9:00AM to 5:00PM EST
Authorized dealer for 12+ brands · Real people on the phone, Mon to Fri
Shop Now
Product support & personalised quotes
Monday to Friday 9:00AM to 5:00PM EST
The AlorAir GE4000TC adds a carpet clamp to the 4000 CFM GE4000T. Tuck the edge of a wet carpet under the clamp and the air blows beneath it as well as across it, which is how restoration crews dry carpet and pad in place.
The 1 HP motor draws 9.4 A at 115 V. A 3-hour dial timer, three speeds and five operating positions carry over from the GE4000T, and the unit weighs 38.05 lbs with molded handles for lifting.
Carpet Clamp
Tuck the carpet edge under the clamp and tighten the screws to blow air beneath the carpet as well as over it.
4000 CFM Centrifugal Blower
A 1 HP motor on 9.4 A drives up to 4000 CFM through a low outlet that sweeps air across wet floors and carpet.
3-Hour Timer
A dial timer counts down up to 180 minutes, then stops the unit. Set it to ON to run continuously.
Three Speeds
A rotary switch sets low, medium or high next to the timer dial.
Five Operating Positions
Runs flat, tilted 10° up or down, at 45° or straight up at 90° to dry floors, walls and ceilings.
20' Power Cord
Reaches outlets across a room without an extension cord, and wraps on the housing for storage.
Stackable Storage
Molded carry handles and a cord wrap on the housing; units stack on their sides up to four high.
Warranty. Backed by AlorAir's 12-month limited warranty from the date of delivery, covering defects in materials and workmanship. AlorAir handles warranty service directly, so keep your proof of purchase and the original packaging.
Shipping. Ships direct from AlorAir's U.S. warehouse, with free shipping on orders over $100.
Inspect on delivery. Check the carton and the unit when it arrives and note any damage on the delivery receipt before signing.
AlorAir Solutions is based in Chino, California, and supplies dehumidifiers, air movers and air scrubbers for water damage restoration, crawl spaces and basements. Its air movers are built to be carried from job to job and work alongside AlorAir's restoration dehumidifiers.
The GE4000 series tops AlorAir's GE air mover range, above the GE3000 (3000 CFM), GE2000 (2000 CFM) and GE1000 (1000 CFM) series. The GE4000T is the base model, the GE4000TC adds a carpet clamp, the GE4000HTC adds wheels, and the GE4000HCW adds a digital panel with app control.
The GE4000 series is the largest of AlorAir's GE air movers, moving up to 4000 CFM from a 1 HP motor. On large open floors, warehouses and commercial losses, fewer units cover the same area.
It draws 9.4 A at 115 V, so give each unit its own 15 A circuit, or close to it, and plug into a GFCI protected outlet.
Beyond water damage, the GE4000 clears fumes and heat from workshops, dries freshly cleaned floors in stores and ventilates warehouses. Three speeds let you back it off when full output is too much.
AlorAir lists an operating range of 23°F to 160°F. Keep the inlets clear of sawdust and debris, and wipe the housing with a damp cloth.
At 37.83 to 40.87 lbs, the GE4000 is a two-hand lift. The HTC and HCW models add a pull-out handle and wheels so one person can roll it across a site, and every model has molded handles and a cord wrap.
Units stack on their sides, up to four high, for storage. Stacks are not secure in transit.
Got Questions?
Find answers below or contact our support team.
It draws 9.4 A at 115 V, so plan on one unit per 15 A circuit. AlorAir specifies GFCI protected outlets and no solid-state speed controllers.
AlorAir rates the GE4000 series at 80 dB, the loudest of the GE series. It is a job-site machine; drop to low speed in occupied buildings.
The suffix letters mark the extras: T is a 3-hour timer, F adds two washable intake filters, C adds a carpet clamp, H adds a pull-out handle with wheels, and W adds a digital panel with an 18-hour timer and app control.
18.6" x 16" x 20.2", and 37.83 lbs (GE4000T) to 40.87 lbs (GE4000HCW).
Yes. The T, TC and HTC models have a 3-hour dial timer; set it to ON to run continuously. The GE4000HCW has a digital timer from 0 to 18 hours.
Proud to Have Served















































