The Empava EMPV-71JT408-BK is a 71" alcove whirlpool tub with 11 jets, a built-in heater and LED lighting. Its built-in heater is made for long, warm soaks; it measures 70.9" L x 33.5" W x 23.6" H, holds 85 gallons and gives a 15" soaking depth, with a center drain.
11 Jets and a 85-Gallon Soak
Eleven jets are driven by a 1.0 HP motor for a strong massage that works into tense muscles, and they adjust in angle and intensity, so the same tub can be turned down for a gentle soak for children. The heater keeps the bath warm through the soak: Empava's manual says it stops automatically once the water reaches 104°F and only runs while the water is at least 77°F.
The acrylic is reinforced with fiberglass, and in Empava's testing it holds water warmth for about 40 minutes. To protect the motor and pumps, the system switches off automatically after 60 minutes of continuous running. The tub also has LED chromotherapy lights.
The faucet, hand shower, headrest, drain and overflow come with the tub. Empty, the tub weighs 225 lbs.
Planning Around a 70.9" x 33.5" Footprint
Plan for an overall size of 70.9" L x 33.5" W x 23.6" H; empty, it weighs 225 lbs. It holds 85 gallons at a 15" soaking depth. The drain is in the center, with a 1.65" opening. Empava's manual plans for a 31.5" drain pipe with the floor drain 12" from the tub drain, and 1/2" hot and cold supply connectors. For power, Empava lists 110/120V, two separate dedicated grounded 15A outlets.
Choosing Within Empava's JT Jetted Tub Range
If you are weighing options within Empava's JT jetted tub range, the models closest in nominal size are the EMPV-71JT408-BN, the EMPV-71JT667B and the EMPV-71JT801. Each is listed with its own photos, specifications and documents, so you can compare size, capacity, jets and drain position against this model.
Empava designs its jetted tubs for fill-and-drain use: the tub is drained after each bath and refilled with fresh water, and the jets run only when the water covers the highest jet by at least 1" to 2". Its manual recommends flushing the pump and pipes before first use and once a month with hot water and a low-foaming detergent, and cleaning hair and lint from the suction cover, so the jets stay clean. Before installation, Empava asks you to run every function with water in the tub for a few minutes and report any defect.
In short, the EMPV-71JT408-BK is an Empava 71" alcove whirlpool tub with 11 jets, a heater, LED lighting and 85 gallons of water.
Features
Built-In Heater
The heater keeps the bath warm for a long soak. It stops at 104°F and runs only when the water is at least 77°F.
Eleven Jets, 1.0 HP
Eleven jets run off a 1.0 HP motor for a strong massage. Angle and intensity adjust for a softer soak when you want one.
85-Gallon, 15" Deep
The 70.9" basin holds 85 gallons at a 15" soaking depth, both figures from Empava's spec tab.
Fiberglass-Reinforced Shell
Fiberglass backs the acrylic for strength, and Empava's tests show it keeps water warm for about 40 minutes.
60-Minute Auto Shut-Off
The motor and pumps switch off after 60 minutes of continuous running. Empava says this ensures safety when no one is present.
Center Drain
The drain is centered, per Empava's spec tab, with the tub listed for alcove or drop-in installation.
Alcove or Drop-In
Empava lists this tub for alcove or drop-in installation. It can sit against the walls or be built into a surround.
Specifications
-
Model: EMPV-71JT408-BK
-
Overall Dimensions: 70.9" L x 33.5" W x 23.6" H
-
Capacity: 85 gallons
-
Soaking Depth: 15"
-
Installation: Alcove or drop-in
-
Material: Acrylic
-
Finish: White
-
Bath Therapy: Whirlpool
-
Number of Jets: 11
-
Heater / Thermostatic System: Yes
-
Lighting: LED ambient, multiple colors
-
Drain Placement: Center
-
Drain Size: 1.65"
-
Recommended Users: 1-person
-
Electrical: 110/120V, two separate dedicated grounded 15A outlets
-
Weight: 225 lbs
-
Warranty: 3-year limited for regular buyers
What's Included
- EMPV-71JT408-BK bathtub
- Faucet
- Hand shower
- Headrest
- Drain
- Overflow
Installation & Care
Installation
Alcove or drop-in install, center drain; overall 70.9" L x 33.5" W x 23.6" H, 225 lbs empty. The tub's drain pipe is 31.5" long, and Empava's manual places the floor drain 12" from the tub drain so the pipe forms an S-bend odor trap; leave a drain opening of at least 2.0". Rough in 1/2" external-thread hot and cold supply connectors that stand 1.18" out from the wall, with a shutoff valve on each line where you can reach it for service. Empava's manual calls for two separate grounded, dedicated 15A outlets, with the external circuit behind a high-sensitivity, fast-trip GFCI (leakage-protection) switch (induced current below 15mA, trip time under 0.1 second, rated current above 30A), installed by a licensed electrician. Before you set it in place, fill the tub and run every function for a few minutes: Empava asks that any defect is reported before installation.
Care
Flush the jet system before first use and once a month: fill with hot water (about 104°F) 0.9" to 1.2" above the jets, add 2 to 3 teaspoons of low-foaming dishwasher detergent, run the jets for 10 minutes and drain, then refill with cold water, run 15 minutes and drain again. Clear hair and lint from the suction cover regularly and never run the jets dry; the water must cover the highest jet by at least 1" to 2". Clean the acrylic with water or a mild detergent; acids, alkalis and solvent cleaners damage the surface. Light scratches can be wet-sanded with 1200 then 2000 grit paper and polished back to a gloss. In freezing weather, drain the tub and its pipes.
Resources
Shipping, Returns & Warranty
Empava ships this item from its warehouse in City of Industry, California, by LTL freight with curbside delivery: the carrier contacts you to schedule the delivery, and you move the item from the curb to its final spot. Orders are processed in 1 to 2 business days and freight transit usually takes 7 to 10 business days; some models are built to order, and we confirm the ship date by email. Shipping is free within the lower 48 states; for Alaska or Hawaii, contact us before you order. You'll get tracking by email as soon as it ships.
Inspect the packaging and the product before you sign. Note any damage or shortage on the delivery receipt, then email photos to support@mycleansupplies.com within 48 hours of delivery so the freight claim can be filed. Damage reported after 48 hours can't be claimed.
Unused Empava products in their original packaging can be returned within 21 days of delivery. Ask us for a return authorization before you ship. You pay the return shipping, which for a tub means freight, and a restocking fee of up to 20% may be deducted along with payment processing fees. Installed, used or damaged products and special-order items can't be returned.
Empava's product page gives regular buyers of this bathtub a 3-year warranty. Empava's warranty policy covers the original purchaser, for everyday home use in the continental US, and Empava supplies replacement parts for covered parts free of charge. The policy does not cover commercial use, improper installation, insufficient or excessive electrical supply, misuse, finish wear from corrosive or abrasive cleaners, consumable parts such as light bulbs and filters, freight damage not recorded at delivery, or the cost of removing, servicing or installing the product.
Warranty claims. To claim the warranty, contact Empava's customer service team at service@empava.com or (888) 682-8882, as Empava's warranty policy directs. Contact us with your order number if you would like help with the claim.
About Empava
Empava is a kitchen and bath brand based in City of Industry, California. Alongside its cooking appliances it designs acrylic freestanding, alcove and corner bathtubs, whirlpool and air-massage tubs, walk-in tubs, outdoor hot tubs and cold plunge tubs, built around fixing the small everyday design flaws that other products leave alone.
Empava's JT line covers its acrylic jetted tubs. It runs from the compact Japanese-style air soakers (47" EMPV-48JT011 and 59" EMPV-59JT011) and the round EMPV-59JT005, through the space-saving EMPV-59JT319LED corner tub and the LED alcove tubs (EMPV-59JT408LED, EMPV-67JT408LED, EMPV-71JT408-BK and EMPV-71JT408-BN), to the combination tubs with waterfalls (the heated EMPV-67JT351LED and the 71" EMPV-71JT351 and EMPV-71JT351-BK) and two-person models such as the EMPV-71JT667B, EMPV-72JT367LED, EMPV-71JT801 and the 75" EMPV-75JT901.
