The AlorAir Storm 80X is an upright commercial dehumidifier with a built-in pump for water damage restoration, construction sites and warehouses. It removes 80 pints a day at AHAM conditions (80°F, 60% RH) and up to 170 pints a day at saturation (90°F, 90% RH), with a 200 CFM airflow, for spaces up to 2,100ft².
A rotomolded, dent-resistant housing, two large wheels and a retractable handle make the Storm 80X easy to roll into tight basements and back out again. It draws 5.3 A and restarts on its own after a power cut.
Available in red, blue, yellow and green, all with the same specifications.
Features
80 Pints a Day at AHAM
Up to 170 pints a day at saturation, from a 200 CFM airflow, rated for spaces up to 2,100ft².
Built-In Condensate Pump
Drains through the included hose; keep the end no higher than 19'. An E4 code on the display flags a drainage problem.
Low 5.3 A Draw
Runs from a grounded 115 V GFCI outlet on a 15 A circuit through a 16.4' cord.
GPP and Error Codes on the LCD
Shows temperature, humidity and grains per pound at the inlet and outlet, job and lifetime hours, and fault codes.
Rotomolded Housing
A dent-resistant polyethylene housing protects the internals on rough job sites, with epoxy powder-coated parts for corrosion protection.
Upright and Mobile
15.2" x 14.4" x 24.8" and 63.9 lbs, on two large wheels with a retractable handle and on-board cord and hose storage.
Automatic Defrost and Memory Restart
Clears ice from the coil in cool spaces and resumes its settings after a power outage.
Specifications
-
Model: Storm 80X
-
Water Removal at AHAM (80°F, 60% RH): 80 pints/day
-
Water Removal at Saturation (90°F, 90% RH): 170 pints/day
-
Coverage: Up to 2,100ft²
-
Airflow: 200 CFM
-
Operating Temperature: 35.6°F to 102.2°F
-
Humidity Setpoint Range: 25% to 80% in 5% steps, plus continuous mode
-
Refrigerant: R32
-
Drainage: Built-in condensate pump, hose end no higher than 19'
-
Power: 115 V, 60 Hz, 5.3 A
-
Electrical Requirement: Grounded 3-prong GFCI outlet, 15 A circuit
-
Power Cord: 16.4'
-
Filter: MERV-1, 13.2" x 11.2" x 0.4"
-
Noise: 60 dBA
-
Dimensions: 15.2"L x 14.4"W x 24.8"H
-
Weight: 63.9 lbs (29 kg)
-
Certifications: cETL
What's Included
- AlorAir Storm 80X dehumidifier
- MERV-1 filter
- Drain hose
- Power cord
- User manual
Setup & Placement
Stand the unit on a stable, level surface with the inlet and outlet clear, and keep windows and doors closed. After transport, let it stand in its normal position for 30 minutes before switching on.
Uncoil the drain hose, connect it to the drain outlet and route it to a sink, floor drain or outside, keeping the end no higher than 19'. Plug into a grounded 3-prong GFCI outlet on a 15 A circuit, with no extension cord.
Resources
Warranty & Shipping
Warranty. Backed by AlorAir's 12-month limited warranty from the date of delivery, covering defects in materials and workmanship. AlorAir handles warranty service directly, so keep your proof of purchase and the original packaging.
Shipping. Ships direct from AlorAir's U.S. warehouse, with free shipping on orders over $100.
Inspect on delivery. Check the carton and the unit when it arrives and note any damage on the delivery receipt before signing.
About AlorAir
AlorAir Solutions is based in Chino, California, and supplies dehumidifiers, air movers and air scrubbers for water damage restoration, crawl spaces and basements. The Storm series is its portable line for contractors who move equipment between job sites.
The Storm 80X is one of AlorAir's upright Storm models on wheels and a handle, alongside the 50-pint Storm DP and the Storm Pro, Ultra and Elite at 85, 90 and 125 pints a day. The low-profile LGR 850 and LGR 1250 suit crews that stack units in a van. For permanent installs, the Sentinel line is the better fit.
