The AlorAir Storm LGR 1250 is a large-capacity low grain refrigerant (LGR) dehumidifier for flood restoration and construction drying. It removes 125 pints a day at AHAM conditions (80°F, 60% RH) with a 300 CFM airflow, covering spaces up to 3,000ft² on an 8.1 A draw.
The low 17.6"-tall rotomolded body rolls on two wheels with a telescopic handle and stacks with other units in a van. A built-in condensate pump empties the Storm LGR 1250 automatically, so it can work through the night on a large-loss job.
Choose the standard LGR 1250 in blue or green, or the red LGR 1250X with WiFi control through the AlorAir app.
Features
125 Pints a Day at AHAM
A 300 CFM airflow at 2.66 L/kWh, rated for spaces up to 3,000ft².
Built-In Condensate Pump
Drains through the included hose on a quick connector, with the outlet no higher than 15'.
8.1 A on a Standard Circuit
Runs from a grounded 115 V GFCI outlet on a 15 A circuit.
GPP at Inlet and Outlet
The LCD shows temperature, humidity and grains per pound at both ends of the airflow, plus job and lifetime hours.
Stackable Rotomolded Shell
The scratch-resistant polyethylene shell opens for access to all components, and units stack for storage and transport.
Low and Mobile
26.1" x 15.5" x 17.6" and 79.2 lbs, on two wheels with a telescopic handle and on-board cord and hose storage.
Replaceable MERV-8 Filter
Slides out of the unit for replacement. Check it at least once a year, and more often on dusty jobs.
WiFi on the LGR 1250X
The red LGR 1250X connects to the AlorAir app for remote monitoring during a drying job.
Specifications
-
Model: Storm LGR 1250 (standard) / Storm LGR 1250X (WiFi)
-
Water Removal at AHAM (80°F, 60% RH): 125 pints/day
-
Coverage: Up to 3,000ft²
-
Airflow: 300 CFM
-
Operating Temperature: 33.8°F to 110°F
-
Humidity Setpoint Range: 25% to 80% in 5% steps, plus continuous mode
-
Drainage: Built-in condensate pump, hose outlet no higher than 15'
-
Power: 115 V, 60 Hz, 8.1 A
-
Electrical Requirement: Grounded 3-prong GFCI outlet, 15 A circuit
-
Efficiency: 2.66 L/kWh
-
Filter: MERV-8
-
Noise: Less than 60 dBA
-
Dimensions: 26.1"L x 15.5"W x 17.6"H
-
Weight: 79.2 lbs (35.9 kg)
-
Certifications: cETL
What's Included
- AlorAir Storm LGR 1250 or LGR 1250X dehumidifier
- MERV-8 filter
- Drain hose
- Power cord
- User manual
Setup & Placement
Stand the unit on a stable, level floor with the inlet and outlet clear, and keep windows and doors closed while it runs. If it was transported on its end, set it back on its wheels and wait 30 minutes before switching on.
Uncoil the drain hose, clip it to the quick connector and route it to a sink, floor drain or outside, with the outlet no higher than 15'. Use a grounded 3-prong GFCI outlet on a 15 A circuit, and no extension cord.
Resources
Warranty & Shipping
Warranty. Backed by AlorAir's 12-month limited warranty from the date of delivery, covering defects in materials and workmanship. AlorAir handles warranty service directly, so keep your proof of purchase and the original packaging.
Shipping. Ships direct from AlorAir's U.S. warehouse, with free shipping on orders over $100.
Inspect on delivery. Check the carton and the unit when it arrives and note any damage on the delivery receipt before signing.
About AlorAir
AlorAir Solutions is based in Chino, California, and supplies dehumidifiers, air movers and air scrubbers for water damage restoration, crawl spaces and basements. The Storm series is its portable line for contractors who move equipment between job sites.
In the Storm range, the LGR 850, LGR 850X and LGR Extreme cover 85 pints a day in a smaller body, while the upright Storm Elite also reaches 125 pints a day with 12" duct connections. The Storm Pro and Ultra sit in between. For permanent installs in basements and crawl spaces, look at the Sentinel line.
