The AlorAir Storm SLGR 1250X is the app-controlled, SLGR version of the Storm LGR 1250. It removes 125 pints a day at AHAM conditions (80°F, 60% RH) and up to 264 pints a day at saturation (90°F, 90% RH), with a 300 CFM airflow, for spaces up to 3,000ft² on 8.1 A.
A microchannel precooler cools incoming air toward its dew point before the evaporator, which AlorAir designed to raise the condensation rate. With a built-in pump and the AlorAir app, the Storm SLGR 1250X suits large-loss restoration jobs you want to monitor from the road.
Features
SLGR Precooling Circuit
An auxiliary refrigerant path with its own expansion device feeds a microchannel precooler, which chills incoming air toward its dew point before the evaporator.
AlorAir App Control
Check readings and adjust the setpoint from your phone, through the unit's hotspot or over WiFi.
125 Pints a Day at AHAM
Up to 264 pints a day at saturation, from a 300 CFM airflow at 2.66 L/kWh.
Built-In Condensate Pump
Drains through the included hose on a quick connector, with the outlet no higher than 15'.
GPP at Inlet and Outlet
The LCD shows temperature, humidity and grains per pound at both ends, with job and lifetime hours.
Low and Stackable
26.1" x 15.5" x 17.6" and 79.2 lbs, on two wheels with a telescopic handle, and units stack for transport.
Replaceable MERV-8 Filter
Slides out of the unit for replacement. Check it at least once a year, and more often on dusty jobs.
Specifications
-
Model: Storm SLGR 1250X (WiFi)
-
Water Removal at AHAM (80°F, 60% RH): 125 pints/day
-
Water Removal at Saturation (90°F, 90% RH): 264 pints/day
-
Coverage: Up to 3,000ft²
-
Airflow: 300 CFM
-
Operating Temperature: 33.8°F to 110°F
-
Humidity Setpoint Range: 25% to 80% in 5% steps, plus continuous mode
-
Drainage: Built-in condensate pump, hose outlet no higher than 15'
-
Power: 115 V, 60 Hz, 8.1 A
-
Electrical Requirement: Grounded 3-prong GFCI outlet, 15 A circuit
-
Power Cord: 19.6'
-
Efficiency: 2.66 L/kWh
-
Filter: MERV-8
-
Noise: Less than 60 dBA
-
Dimensions: 26.1"L x 15.5"W x 17.6"H
-
Weight: 79.2 lbs (35.9 kg)
-
Certifications: cETL
What's Included
- AlorAir Storm SLGR 1250X dehumidifier
- MERV-8 filter
- Drain hose
- Power cord
- User manual
Setup & Placement
Stand the unit on a stable, level floor with the inlet and outlet clear, and keep windows and doors closed while it runs. If it was transported on its end, set it back on its wheels and wait 30 minutes before switching on.
Uncoil the drain hose, clip it to the quick connector and route it to a sink, floor drain or outside, with the outlet no higher than 15'. Use a grounded 3-prong GFCI outlet on a 15 A circuit, and no extension cord.
Resources
Warranty & Shipping
Warranty. Backed by AlorAir's 12-month limited warranty from the date of delivery, covering defects in materials and workmanship. AlorAir handles warranty service directly, so keep your proof of purchase and the original packaging.
Shipping. Ships direct from AlorAir's U.S. warehouse, with free shipping on orders over $100.
Inspect on delivery. Check the carton and the unit when it arrives and note any damage on the delivery receipt before signing.
About AlorAir
AlorAir Solutions is based in Chino, California, and supplies dehumidifiers, air movers and air scrubbers for water damage restoration, crawl spaces and basements. The Storm series is its portable line for contractors who move equipment between job sites.
In the Storm range, the LGR 850, LGR 850X and LGR Extreme cover 85 pints a day in a smaller body, while the upright Storm Elite also reaches 125 pints a day with 12" duct connections. The Storm Pro and Ultra sit in between. For permanent installs in basements and crawl spaces, look at the Sentinel line.
