The ANZZI TW-AZ026MBK is a tall, eight-bar towel warmer, finished in matte black. From ANZZI's Bell Series, this wall-mounted electric towel warmer rack is built from Rhino Alloy certified stainless steel and measures 23.6" L x 4.3" W x 36.25" H.
A Warm Towel After Every Shower
The Bell warms up in 20 minutes or less. A digital control panel on the frame sets a 2-hour or 4-hour heating cycle, so the rack shuts off on its own at the end of the cycle you choose. Eight evenly spaced bars run up a 36.25" tall frame in a modern, minimalist design, giving the rail length for larger towels and robes.
Rhino Alloy Certified Construction
The Bell is built from Rhino Alloy certified rust-resistant stainless steel for durability, strength and long-lasting performance. The matte black finish is one of the 3 finishes this model is offered in, each listed under its own model number.
It draws 80 W at 110V, is energy efficient and is UL certified. You choose how it is powered: plug it into a GFCI-protected outlet using the cord, or have it hardwired to a wall supply for a clean wall with no visible cable.
Planning the Installation
The rack is 36.25" tall and 4.3" deep.
The manual calls for a pencil, hammer, tape measure, electric drill, Phillips screwdriver, level and gloves. Screw expansion tubes are knocked into the drilled holes, the fixing blocks go onto the wall with self-tapping screws, and the rack is test-fitted on the blocks to confirm it is level before those screws are fully tightened. A tapered set screw, tightened with the supplied hex wrench, then locks the rack to each wall mount.
For a hardwired install, switch the circuit breaker off at the main panel first. The cord ends are stripped and joined to the supply in the junction box with wire nuts, and the hardwired wall mounting plate is screwed over the connection. The supply circuit must have an over-current protection device.
Use it for towels and bathrobes only. The bars get very hot while it runs, so do not touch them in use, and never stand, sit or climb on the rack.
For anyone comparing heated towel racks, the ANZZI TW-AZ026MBK gives you 8 evenly spaced bars, stainless steel construction and a wall install in matte black.
Features
8 Heated Bars
The Bell is a one-piece towel warmer with 8 evenly spaced heated bars in a modern contemporary design.
Warm in 20 Minutes or Less
The rack warms up in 20 minutes or less, so a fresh, warm towel is ready when you step out of the shower.
2-Hour and 4-Hour Timer
The digital control panel offers convenient 2-hour and 4-hour timer options for precise heating control.
Hardwired or Plug-In
Run it from a GFCI-protected outlet with the supplied cord, or hardwire it to a wall supply.
Rhino Alloy Certified Stainless Steel
ANZZI builds the Bell from Rhino Alloy certified rust-resistant stainless steel, built for durability and long-lasting performance.
80 W, UL Certified
With 80 watts of power on 110V, the Bell gives reliable, eco-friendly warmth and is UL certified.
Overall Size
Overall it measures 23.6" L x 4.3" W x 36.25" H, so measure the wall section, including the clearance to doors and fixtures, before you order.
Matte Black Finish
This Bell rack is finished in matte black, and the same model also comes in brushed nickel and polished chrome.
Specifications
-
Model: TW-AZ026MBK
-
Dimensions: 23.6" L x 4.3" W x 36.25" H
-
Material: Rhino Alloy certified stainless steel
-
Finish: Matte Black
-
Heated Bars: 8
-
Installation: Wall mount; plug-in or hardwired
-
Controls: Digital control panel, 2-hour or 4-hour timer
-
Warm-Up Time: 20 minutes or less
-
Wattage: 80 W
-
Voltage: 110V
-
Certification: UL
-
Bracket Spacing: 22.44" and 29.13"
-
Series: Bell
-
Warranty: Limited lifetime (register within 90 days)
What's Included
- TW-AZ026MBK Bell 8-bar towel warmer
- Power cord
- Wall mounting brackets, fixing blocks, expansion anchors and screws
- Hex wrench
Installation & Care
Installation
Mark the bracket positions (22.44" and 29.13" apart on this model), keep the bottom of the rack at least 23.62" (600 mm) off the floor and level, drill with an 8 mm bit, fit the expansion anchors and hang the rack on the fixing blocks. Plug-in: connect to a GFCI-protected, grounded outlet. Hardwired: the cord is cut and connected to a wall supply with the power off at the breaker; ANZZI's manual refers any doubt about grounding to a qualified electrician. Place it so the controls cannot be reached from the bath or shower.
Care
Wipe the bars with a soft cloth with the power off and the rack cool. Any hard scrubbing or scratching on the product surface is strictly prohibited.
Resources
Shipping, Returns & Warranty
ANZZI ships this item from the SW Corp warehouse by UPS, FedEx or USPS, usually within 1 to 2 business days of your order. Shipping is free within the lower 48 states on orders of $101 or more (orders under $101 ship for a flat $15); for Alaska or Hawaii, contact us before you order. You'll get tracking by email as soon as it ships.
Inspect the packaging and the product before you sign. Note any damage or shortage on the delivery receipt, then email photos to support@mycleansupplies.com within 48 hours of delivery so the freight claim can be filed. Damage reported after 48 hours can't be claimed.
Unused ANZZI products in their original packaging can be returned within 21 days of delivery. Ask us for a return authorization before you ship. You pay the return shipping, which for a freight item means the freight cost, and a 20% restocking fee is deducted along with payment processing fees. Installed, used or damaged products and special-order items can't be returned.
ANZZI warrants this towel warmer to the original purchaser against defects in materials and workmanship for its lifetime, for residential use, and replaces a defective product or part free of charge. Register it at anzzi.com/register within 90 days of delivery to activate the warranty, and report any surface damage within 5 days of delivery, before installation. Shipping, handling and labor costs, commercial use, improper installation or maintenance, misuse, hard-water or mineral deposits and corrosive cleaners are not covered.
Warranty claims. Call ANZZI at 1-844-442-6994 (1-844-44-ANZZI) with your proof of purchase to submit a claim and get a return authorization (RMA). Register the product at anzzi.com/register within 90 days of delivery, or the warranty is not active. Contact us with your order number if you would like help with the claim.
About ANZZI
ANZZI is a kitchen and bath brand from SW Corp, a Miami, Florida company that also makes SteamSpa and MediTub. It designs freestanding and walk-in bathtubs, shower doors and bases, faucets, sinks, toilets and kitchen fixtures, bringing European bath design to North American homes.
The Bell is one of ANZZI's electric towel warmers. This model comes in brushed nickel (TW-AZ026BN), polished chrome (TW-AZ026CH) and matte black (TW-AZ026MBK).
