The Empava EMPV-59AIS15 is a 59" rectangular freestanding whirlpool tub, a standard single tub with a generous 60-gallon capacity for a full-body soak. It measures 59.06" L x 29.53" W x 22.05" H with a 13" soaking depth, and the faucet and hand shower come with it. Empava says it suits body types from slim to busty.
8 Jets and a 60-Gallon Soak
The interior has no corner cut-outs, so you can extend your legs fully, and the floor of the basin is 39.4" long and 20.9" wide. Empava says all it takes is a perpendicular corner for the tub to fit in.
Jets are placed symmetrically at both ends, with a dual-end headrest design, so the massage on your back, waist and legs is the same whichever way you lie. Eight jets run off a pump that plugs into a grounded 110/120V, 15 amp outlet.
Empava uses acrylic for its low upkeep and hygiene: the non-porous shell does not let mildew or mold take hold and does not absorb water, so it resists cracking over time. The tub weighs 108.03 lbs empty and has no heater; if you want heated water, Empava points to its EMPV-59JT319LED and EMPV-67JT351LED.
Planning Around a 59.06" x 29.53" Footprint
Plan for an overall size of 59.06" L x 29.53" W x 22.05" H; empty, it weighs 108.03 lbs. It holds 60 gallons at a 13" soaking depth. The drain is in the center, with a 1.65" opening. Empava's manual plans for a 31.5" drain pipe with the floor drain 12" from the tub drain, and 1/2" hot and cold supply connectors. For power, Empava lists 110/120V, 15A.
Choosing Within Empava's AIS Whirlpool Range
If you are weighing options within Empava's AIS freestanding whirlpool range, the models closest in nominal size are the EMPV-59AIS04, the EMPV-59AIS06 and the EMPV-59AIS36-BN. Each is listed with its own photos, specifications and documents, so you can compare size, capacity, jets and drain position against this model.
Empava designs its jetted tubs for fill-and-drain use: the tub is drained after each bath and refilled with fresh water, and the jets run only when the water covers the highest jet by at least 1" to 2". Its manual recommends flushing the pump and pipes before first use and once a month with hot water and a low-foaming detergent, and cleaning hair and lint from the suction cover, so the jets stay clean. Before installation, Empava asks you to run every function with water in the tub for a few minutes and report any defect.
In short, the EMPV-59AIS15 is an Empava 59" freestanding whirlpool tub with 8 jets and 60 gallons of water.
Features
Full-Length Leg Room
The basin floor runs 39.4" long and 20.9" wide with no corner cut-outs. Empava says the shape allows full-leg extension for bathers from slim to busty.
60-Gallon Soak
The rectangular shell holds 60 gallons at a 13" depth. Empava calls it a generous capacity for a full-body soak.
Fits a Perpendicular Corner
Empava says all it takes is a perpendicular corner. The tub can then blend in without the need for any complex design techniques.
Symmetrical Jets, Dual-End Headrest
Jets are mirrored at both ends with a dual-end headrest design. You get the same massage on the back, waist and legs facing either way.
Eight Jets, One Pump
Eight jets run off one pump on a grounded 110/120V, 15 amp outlet. The outlet needs the grounding and leakage protection Empava's manual specifies.
Mildew-Resistant Acrylic
The non-porous acrylic gives mildew and mold nowhere to grow and does not soak up water. Empava says it resists cracking and keeps heat well.
Fixtures Included
The faucet, hand shower, drain, drain pipe and overflow come with the tub, along with the headrest Empava's spec tab lists.
Specifications
-
Model: EMPV-59AIS15
-
Overall Dimensions: 59.06" L x 29.53" W x 22.05" H
-
Capacity: 60 gallons
-
Soaking Depth: 13"
-
Installation: Freestanding
-
Shape: Rectangle, double-ended
-
Material: Acrylic
-
Finish: White
-
Bath Therapy: Whirlpool
-
Number of Jets: 8
-
Heater / Thermostatic System: No
-
Drain Placement: Center
-
Drain Size: 1.65"
-
Recommended Users: 1-person
-
Electrical: 110/120V, 15A
-
Weight: 108.03 lbs
-
Basin Floor: 39.4" L x 20.9" W
-
Warranty: 3-year limited for regular buyers
What's Included
- EMPV-59AIS15 bathtub
- Faucet
- Hand shower
- Headrest
- Drain
- Drain pipe
- Overflow
Installation & Care
Installation
Freestanding, center drain; overall 59.06" L x 29.53" W x 22.05" H, 108.03 lbs empty. The interior basin floor is 39.4" x 20.9". The tub's drain pipe is 31.5" long, and Empava's manual places the floor drain 12" from the tub drain so the pipe forms an S-bend odor trap; leave a drain opening of at least 2.0". Rough in 1/2" external-thread hot and cold supply connectors that stand 1.18" out from the wall, with a shutoff valve on each line where you can reach it for service. The pump runs on a grounded 15A outlet, with the external circuit behind a high-sensitivity, fast-trip GFCI (leakage-protection) switch (induced current below 15mA, trip time under 0.1 second, rated current above 30A), installed by a licensed electrician as Empava specifies. Before you set it in place, fill the tub and run every function for a few minutes: Empava asks that any defect is reported before installation.
Care
Flush the jet system before first use and once a month: fill with hot water (about 104°F) 0.9" to 1.2" above the jets, add 2 to 3 teaspoons of low-foaming dishwasher detergent, run the jets for 10 minutes and drain, then refill with cold water, run 15 minutes and drain again. Clear hair and lint from the suction cover regularly and never run the jets dry; the water must cover the highest jet by at least 1" to 2". Clean the acrylic with water or a mild detergent; acids, alkalis and solvent cleaners damage the surface. Light scratches can be wet-sanded with 1200 then 2000 grit paper and polished back to a gloss. In freezing weather, drain the tub and its pipes.
Resources
Shipping, Returns & Warranty
Empava ships this item from its warehouse in City of Industry, California, by LTL freight with curbside delivery: the carrier contacts you to schedule the delivery, and you move the item from the curb to its final spot. Orders are processed in 1 to 2 business days and freight transit usually takes 7 to 10 business days; some models are built to order, and we confirm the ship date by email. Shipping is free within the lower 48 states; for Alaska or Hawaii, contact us before you order. You'll get tracking by email as soon as it ships.
Inspect the packaging and the product before you sign. Note any damage or shortage on the delivery receipt, then email photos to support@mycleansupplies.com within 48 hours of delivery so the freight claim can be filed. Damage reported after 48 hours can't be claimed.
Unused Empava products in their original packaging can be returned within 21 days of delivery. Ask us for a return authorization before you ship. You pay the return shipping, which for a tub means freight, and a restocking fee of up to 20% may be deducted along with payment processing fees. Installed, used or damaged products and special-order items can't be returned.
Empava's product page gives regular buyers of this bathtub a 3-year warranty. Empava's warranty policy covers the original purchaser, for everyday home use in the continental US, and Empava supplies replacement parts for covered parts free of charge. The policy does not cover commercial use, improper installation, insufficient or excessive electrical supply, misuse, finish wear from corrosive or abrasive cleaners, consumable parts such as light bulbs and filters, freight damage not recorded at delivery, or the cost of removing, servicing or installing the product.
Warranty claims. To claim the warranty, contact Empava's customer service team at service@empava.com or (888) 682-8882, as Empava's warranty policy directs. Contact us with your order number if you would like help with the claim.
About Empava
Empava is a kitchen and bath brand based in City of Industry, California. Alongside its cooking appliances it designs acrylic freestanding, alcove and corner bathtubs, whirlpool and air-massage tubs, walk-in tubs, outdoor hot tubs and cold plunge tubs, built around fixing the small everyday design flaws that other products leave alone.
The AIS series is Empava's freestanding acrylic whirlpool range. The classic models ship with the faucet, hand shower, drain, overflow and headrest, in 59" oval, double-ended, boat and rectangle shells (EMPV-59AIS04 to EMPV-59AIS15), ten 67" designs from oval and double-ended to high-back and boat (EMPV-67AIS01 to EMPV-67AIS17), and two 71" models, the double-ended EMPV-71AIS08 and boat-style EMPV-71AIS14. The newer LED models, such as the EMPV-59AIS36-BN and EMPV-67AIS38-BN, raise the count to 16 or 18 jets and add color lighting.
